user:

Satin Nickel 8 in. Back-To-Back Solid Brass Pull Handles with Washers

SPH8
SPH8 - 8" Bk to Bk Pull+Washers Solid
  • Fits 1/4 in. to 1/2 in. Thick Glass
  • Hole Diameter Required: 1/2 Inch
  • Solid Brass Construction
  • Three Year Waranty
  • These Solid Brass Pull Handles offer a selection of Back-to Back or Single-Sided styles, with choice of an economical in.no washer in. type, or the traditional style pull with 1-1/4 inch diameter metal washers.The Back-To-Back Handle includes a pull for each side of the door, and is commonly used frameless shower door applications.The Single-Sided Handle has a 1/8 inch protruding end cap, and is commonly used for by-passing doors, cabinets and wardrobe doors.All Pull Handles are offered in a choice of 6 and 8 inch sizes, and are stocked in finishes to match most bathroom decors.

Weight & Width*
Glass**
Glass***
2 Hinges (Max Door Width)
2 Hinges ( Max Door Weight)
3 Hinges (Max Door Width )
3 Hinges (Max Door Weight )

  lbs.

* NOTE: Do not exceed either maximum weight or width when choosing proper quantity of hinges.

Glass Cutout:

The cutout for the hinge allows some adjustment in door position after installation. The positioning of the cutout is subjective, but tempering facilities have minimum distances from the end of the glass to the notch. It is important that the hinge is centered in the cutout for the initial installation to have maxium adjustiability.

 

SPH8 Cutout

Maintenance Guidelines:

• Our hinges are greased at the factory for quiet and trouble-free operation. If there is any squeaking that occurs after installation, put a drop of "3 in 1 Oil" (also known as "household oil") on the white nylon washer that the hinge body pivots on. This washer is the component that acts as a buffer, so the body of the hinge doesn't pivot directly on the brass center block. This solution doesn't require the disassembly of the hinge.
Note: Do not use spray lubricant on these hinges. If the hinge has been disassembled, upon re-assembly, use white lithium grease to lubricate the interior mechanism.

Never use an abrasive cleaner on the hardware. Many of the components are coated with a clear lacquer that will be irreparably damaged if subjected to harsh, abrasive chemicals. Advise your customer that drying the hardware with a clean, soft towel on a daily basis is the best way to maintain the hardware. If mineral deposits build-up, mix a couple of drops of a mild liquid soap (such as Ivory or a similar product) into a cup of warm water. Using a soft, non-abrasive cloth, clean the hardware. Rinse thoroughly with clean, warm water and dry.