user:

Zurich 07 Series Oil Rub Bronze Glass-to-Glass Inline Outswing Hinge

ZUR07
180 Degree Inline Outswing Hinge
  • Ideal for Bi-Fold Application
  • Available in Several Beautiful Finishes
  • The Zurich 07 Series of professional hinges is able to accommodate 5/16 to 3/8 inch (8 to 10 millimeter) tempered safety glass. A variety of 6 styles, including Wall Mount and Glass-to-Glass types, gives design flexibility.All six styles of Zurich Hinges feature stainless steel construction and are available in seven finishes.The brass finish is also available in solid brass construction with a protective coating. In addition, screws and washers are interchangeable for a special design accent. Only two holes per attachment are required, with no cut-out necessary.

Weight & Width*
5/16" ( 8 mm ) Glass**
3/8" ( 10 mm ) Glass***
2 Hinges (Max Door Width)

36  in.

36  in.

2 Hinges ( Max Door Weight)

100  lbs.

100  lbs.

3 Hinges (Max Door Width )

40  in.

40  in.

3 Hinges (Max Door Weight )

150  lbs.

150  lbs.

* NOTE: Do not exceed either maximum weight or width when choosing proper quantity of hinges.

** 5/16" glass weighs 4.20 lbs. per sq.ft.

*** 3/8" glass weighs 4.78 lbs. per sq.ft.

Glass Cutout:

The cutout for the hinge allows some adjustment in door position after installation. The positioning of the cutout is subjective, but tempering facilities have minimum distances from the end of the glass to the notch. It is important that the hinge is centered in the cutout for the initial installation to have maxium adjustiability.

 

ZUR07 Cutout

Maintenance Guidelines:

• Our hinges are greased at the factory for quiet and trouble-free operation. If there is any squeaking that occurs after installation, put a drop of "3 in 1 Oil" (also known as "household oil") on the white nylon washer that the hinge body pivots on. This washer is the component that acts as a buffer, so the body of the hinge doesn't pivot directly on the brass center block. This solution doesn't require the disassembly of the hinge.
Note: Do not use spray lubricant on these hinges. If the hinge has been disassembled, upon re-assembly, use white lithium grease to lubricate the interior mechanism.

Never use an abrasive cleaner on the hardware. Many of the components are coated with a clear lacquer that will be irreparably damaged if subjected to harsh, abrasive chemicals. Advise your customer that drying the hardware with a clean, soft towel on a daily basis is the best way to maintain the hardware. If mineral deposits build-up, mix a couple of drops of a mild liquid soap (such as Ivory or a similar product) into a cup of warm water. Using a soft, non-abrasive cloth, clean the hardware. Rinse thoroughly with clean, warm water and dry.